PLC display and input parameter display board, function is equivalent to text, touch screen does not need to be programmed The latest addition to the new digital display has the following differences:1. In the past, the digital tube used a 0.36 inch digital tube, and the new one was changed to 0.56 inch, making the numbers look clearer.The display of 2.4 LED indicators is protected against crosstalk.3. The button distance is longer, making it easier to operate the button switch.4. The dimensions are long and wide, but the thickness is thinner.5. With 4 slabs on one side, the installation is more stable.6. The method of operation used is the same as before. The new single row and double row outer dimensions are the same: length * width * thickness 105 * 53 * 19MM opening size: 101 * 51.5MM This digital tube display can be connected with domestic PLC produced by the company (all the PLC of the company for sale can be connected), which can replace the touch screen and text on small equipment, and has a very high price ratio. In many projects, it can also replace the development of single-chip microcomputers, with short development cycle, mature circuit, stable and reliable. You can also use our digital display board to take the board, generation counter, timer, flexible programming of PLC according to your own place of use to adapt to different requirements, avoiding the general-purpose counters on the market, the timer is not flexible in use. CaseVery simple to use, no programming, direct useThere are two modes in total, one is the main mode, and the other is the input parameter mode.When it is powered on, it enters the main mode. In this mode, the upper row of digital tubes displays the value of D110. The lower row of digital tubes shows the value of D114The push button switch controls the closing and opening of the corresponding intermediate relay (M), and the indicator light is controlled to be on and off according to the closing and opening of the internal intermediate relay (M).Press the SET button for 3 seconds to enter the parameter mode. In the parameter mode, the value of the data register D200 can be changed. The upper row of digital tubes (the board of the double-row digital tube) or the left two digits of the digital tube (the board of the single-row digital tube) are used to display the data register to be changed. The number can be changed by pressing the upper triangle key (increase) and pressing the triangle key (decrease). When changing, the value read will be in the lower row of digital tubes (the board of the double-row digital tube) or the right 4 digits (single) The panel of the digital tube is displayed, and the UP and DOWN can also be used to change the value. Note: When the single-row digital tube enters the input parameter mode, the d0 displayed on the left side corresponds to the D register of the actual PLC. The d1 displayed on the left side corresponds to the D register of the PLC corresponding to D201, and so on. After changing the value, press the SET button for 3 seconds to enter the main mode.Single row and double row dimensions are the same size: length * width * thickness 79 * 43 * 27MM opening size: 75 * 40Shell color: gray This display board occupies the following resources of PLC, please pay attention to PLC programmingEnvios y Entregas - Se hacen despachos por pagar a otras ciudades - Entregas por mano solo se hacen de lunes a Viernes en el centro de Viña en la Mañana a las 11:30.- Despachos para compras antes de las 11.00 se hacen en el dia Notas- Si está publicado es por que hay stock - Cualquier pregunta, no dude en consultar